hornady 9mm 115 xtp-COL

Discussions covering the components and techniques of reloading for your handgun.
User avatar
Poppop
250 Shots
250 Shots
Posts: 262
Joined: 02 Mar 2014 16:15
My Press Choice: Turret
Location: Easton, PA
Has thanked: 82 times
Been thanked: 53 times

hornady 9mm 115 xtp-COL

Post by Poppop »

Hi Guys
Needed to load 9mm. Bought box of Hornady 115gr XTP. Using WSF Powder.
Checked Lee book and Hogdgen online. Neither have info for WSF powder for this particular bullet. Most if not all books call for a COL of 1.169 for WSF powder.
Lee does not have a WSF listed for 115 XTP and Hogdgen calls for JHP (similar point as XTP) at COL 1.125
Anyone have any advise
Thanks
+guns +guns +guns
If all else fails--look for the obvious
MAGA
cj8281
250 Shots
250 Shots
Posts: 255
Joined: 03 Jan 2017 10:58
My Press Choice: Turret
Location: Utah
Has thanked: 56 times
Been thanked: 85 times

Re: hornady 9mm 115 xtp-COL

Post by cj8281 »

Never seen that, the COL is usually determined by the bullet not the powder, for a particular cartridge.

Just went and looked and that is how it is listed on Hodgdon's website. Don't know their reasoning for it other than to reduce the pressure. If you load that long, you do need to check and make sure your bullet is not engaging the rifling of your barrel. That will give you over pressure too.

As far as advice, I would think about changing powder, HP-38/W231 give very similar performance (on paper) to what is listed for WSF.
cj8281
250 Shots
250 Shots
Posts: 255
Joined: 03 Jan 2017 10:58
My Press Choice: Turret
Location: Utah
Has thanked: 56 times
Been thanked: 85 times

Re: hornady 9mm 115 xtp-COL

Post by cj8281 »

I did find this and thought you might like it to read:
https://forums.1911forum.com/showthread.php?t=478635
Post #16
User avatar
Macd
Supporter
Supporter
Posts: 1009
Joined: 16 Oct 2017 16:12
My Press Choice: Single Stage
Location: Far East
Has thanked: 362 times
Been thanked: 403 times

Re: hornady 9mm 115 xtp-COL

Post by Macd »

Bullets with large hollow points take up more case space compared to a regular bullet of the same weight as they may be deeper seated in the case. In a 9mm this means higher pressures. Lee specifically mentions this on page 158 of the second edition manual. My own experience is this is borne out by higher velocity and more felt recoil. I shot two lots of Berry's bullets, both 124 grain, a RN and a HP. OAL's were 1.120 and 1.060 respectively. This placed both bullets just off the lands of my M&P9. The HP was seated deeper in the case to get it to this position. The results were that the HP's averaged 30-70 FPS greater velocity for the same charges of W231. I kept the maximum load for the HP to 0.2 grains below the RN and it still showed a slightly higher FPS. No experience with WSF but checking the Hodgdon site shows that the 115 JHP shows higher velocity and greater pressure for the same C.O.L and maximum load of WSF as the FMJ bullet. This is inline with my own results.
User avatar
Poppop
250 Shots
250 Shots
Posts: 262
Joined: 02 Mar 2014 16:15
My Press Choice: Turret
Location: Easton, PA
Has thanked: 82 times
Been thanked: 53 times

Re: hornady 9mm 115 xtp-COL

Post by Poppop »

For experimental purposes I loaded 15 rd ea. of 5.2, 5.4 gr @ 1.125 COL and 10 rd of 5.6 gr @ 1.169 COL
If my hand survives, I will let you guys know what the outcome is.
Thanks
If all else fails--look for the obvious
MAGA
User avatar
Ranch Dog
Site Admin
Site Admin
Posts: 6456
Joined: 22 Jun 2013 17:16
My Press Choice: Progressive
Location: Inez, TX
Has thanked: 1616 times
Been thanked: 2850 times

Re: hornady 9mm 115 xtp-COL

Post by Ranch Dog »

Poppop wrote:For experimental purposes I loaded 15 rd ea. of 5.2, 5.4 gr @ 1.125 COL and 10 rd of 5.6 gr @ 1.169 COL
If my hand survives, I will let you guys know what the outcome is.
Thanks
Image\

+corn
Michael
Image
User avatar
Macd
Supporter
Supporter
Posts: 1009
Joined: 16 Oct 2017 16:12
My Press Choice: Single Stage
Location: Far East
Has thanked: 362 times
Been thanked: 403 times

Re: hornady 9mm 115 xtp-COL

Post by Macd »

LOL So no report means no fingers.
User avatar
Ranch Dog
Site Admin
Site Admin
Posts: 6456
Joined: 22 Jun 2013 17:16
My Press Choice: Progressive
Location: Inez, TX
Has thanked: 1616 times
Been thanked: 2850 times

Re: hornady 9mm 115 xtp-COL

Post by Ranch Dog »

Macd wrote:LOL So no report means no fingers.
That's the way I see it!
Michael
Image
User avatar
Poppop
250 Shots
250 Shots
Posts: 262
Joined: 02 Mar 2014 16:15
My Press Choice: Turret
Location: Easton, PA
Has thanked: 82 times
Been thanked: 53 times

Re: hornady 9mm 115 xtp-COL

Post by Poppop »

Macd wrote:LOL So no report means no fingers.


That's why I say "WHAT--ME WORRY?"
+guns +guns +guns
If all else fails--look for the obvious
MAGA
User avatar
GasGuzzler
Moderator & Supporter
Moderator & Supporter
Posts: 2035
Joined: 26 Jan 2016 22:39
My Press Choice: Turret
Location: Cooke County, TX
Has thanked: 330 times
Been thanked: 500 times

Re: hornady 9mm 115 xtp-COL

Post by GasGuzzler »

I am pretty sure I posted this but.....

I went the other way with 9X19. I made my OAL longer for my P95 and added powder over the book recipe to make up for the extra case space. I crawled up to the load slowly and checked it for accuracy.
__________________________________________________________________________________________
I've always been crazy but it's kept me from goin' insane.
Post Reply

Return to “Handgun Reloading”