If any of you have the collet sizing die for the 6.5CM could you measure the diameter of the mandrel. Appreciate it, thanks.
Make smoke,
6.5 Creedmoor collet die
-
- Supporter
- Posts: 888
- Joined: 06 Mar 2016 16:09
- My Press Choice: Hand Press
- Location: SW Ohio
- Has thanked: 156 times
- Been thanked: 240 times
6.5 Creedmoor collet die
Curt.......makin' smoke and raising my carbon foot print one cartridge at a time
- RBHarter
- Founding Member
- Posts: 2047
- Joined: 13 Mar 2014 19:45
- My Press Choice: Single Stage
- Location: The green hell 90 miles north of Texarka
- Has thanked: 76 times
- Been thanked: 672 times
Re: 6.5 Creedmoor collet die
I don't have one but in a perfect world it should .261-.262 if it is a sizing stop if it is a withdrawal expander it should be .262-263 . Either way it will give you a .2615-.2625 finish ID for 2-3x fired brass and .0005 smaller for annealed and larger for 4x plus . It's the work hardening and spring back with a goal of .002 neck tension .
Just a Red neck,White boy, Blue blood American.....