Page 1 of 1
Hello from SW Pa
Posted: 18 Dec 2016 11:41
by RK724
Hi folks, I have been reloading for the past 6 years, love the hobby. I'm currently using the LCT with the reverse indexing bullet ejector from Inline Fab. I also use a Hornady bullet feeder die when loading 9mm & .38spl. I believe those mods change the LCT from a nice press to a great press. I also load .223 on it as well. But what brings me here is I am upgrading to a Loadmaster, and I was looking for a resource to help me workout any issues I encounter. Look forward to hearing from you all.
Re: Hello from SW Pa
Posted: 18 Dec 2016 12:12
by 357cyrus
Welcome aboard! I'm sure you'll find the answers you're looking for here... without all the run around you find on other forums.
Re: Hello from SW Pa
Posted: 18 Dec 2016 12:14
by 357cyrus
Almost forgot to ask... Where at in PA? I've spent quite a bit of time just north of Pittsburgh.
Re: Hello from SW Pa
Posted: 18 Dec 2016 19:48
by akuser47
Welcome
Re: Hello from SW Pa
Posted: 19 Dec 2016 03:25
by Fyodor
Herzlich willkommen from Germany!
The classic turret is a great press, especially with the auto case kicker.
Re: Hello from SW Pa
Posted: 19 Dec 2016 05:20
by Ranch Dog
Welcome to the forum!
I have three Load-Masters that have been out of service for a year. Took them down so I could get a bench off the wall for paint. Started putting them back together yesterday evening and so far the 45 Auto is going great. The hard stuff is done, priming and Pro Auto Disk setup. Going out in a bit to finish up the bullet feeder/seating and crimp dies in just a bit.
I tried to do this when I was in a big hurry last year, needing ammo, and really got frustrated with the presses.
Re: Hello from SW Pa
Posted: 19 Dec 2016 18:28
by Old Scribe
Welcome aboard from the State of Jefferson.