Pro Auto Disk - breaking chains
Posted: 18 May 2017 22:07
got a Loadmaster yesterday and began the set-up process. Got to the powder set-up and selected a couple of disks for my target 9 loads. I check each dispensed case and found I needed to get a larger diameter to reach what I have been loading. All went well till the last disk selection.
The first attempt to fill a case resulted in a broken return chain. I found the lever on the measure hanging on return to a closed position. I attempted to isolate the cause by removing the hopper then the disks but no answer there. Clean the slider in the die... worked for a while and then failed again.
Filled out a "ticket" for help from support and within an hour had a call setting up the parts I needed to resolved the issue. The tech judged the issue to be the "down tube" in the body of the measure. I'm hoping I get the new one in place without damaging it.
Thanks for a great job of support from tech support. I'll post results
P.S. go easy on me I'm a noob to Lee.
The first attempt to fill a case resulted in a broken return chain. I found the lever on the measure hanging on return to a closed position. I attempted to isolate the cause by removing the hopper then the disks but no answer there. Clean the slider in the die... worked for a while and then failed again.
Filled out a "ticket" for help from support and within an hour had a call setting up the parts I needed to resolved the issue. The tech judged the issue to be the "down tube" in the body of the measure. I'm hoping I get the new one in place without damaging it.
Thanks for a great job of support from tech support. I'll post results
P.S. go easy on me I'm a noob to Lee.