Primer Light for LoadMaster
Posted: 11 May 2018 10:24
Some time ago I installed a primer light for station 3. I really like it. I very seldom have a missing primer, but when I do, this let's me know right away. In fact, it's actually a little brighter than shown in the picture. It's also more effective with water tumbled clean brass. I can actually use it with tumbled .223/5.56 brass if I want to prime on press. Again, my primer works very well.
I ran my wiring up through the ram. I'm funny about drilling into my reloading equipment.
One caveat: The light tends to wash out, if you are running LED lighting on your press or you try to use it directly under bright florescence. You don't have to run in the dark, you just have to be careful with the lighting.
I ran my wiring up through the ram. I'm funny about drilling into my reloading equipment.
One caveat: The light tends to wash out, if you are running LED lighting on your press or you try to use it directly under bright florescence. You don't have to run in the dark, you just have to be careful with the lighting.