First-run camlock Pro from Nightmare 2 sweet dream
Posted: 03 May 2020 11:32
Starting off the first run of 45 ACP on the newly set-up cam lock Pro. Shortly after a few rounds I began to have difficulty. The case feeder was kicking out cases sideways. Safety Prime was throwing primers on the floor and I was having difficulty fully seating primers with the Press. I went back looked at everything I had set up and it appeared correct. I took a break to think about it and then decided to break everything down back to the basic press and this is what I found.
There were spent primers not going through the ram to the primer storage. They had built up under the shell plate. I cleared the obstruction cleaned everything very well and then reassembled the Press. Since I had everything apart I reinstalled the brass feeder and took out the plastic spring of the Lee safety Prime and as I've seen on YouTube placed a quarter inch Bolt spreading it apart and then dropped it in boiling water for 5 minutes.
Well I ran 25 rounds without a problem without dropping a single primer and with all cases feeding properly. The nightmare seems to be over. The loads are mixed brass Sierra 230 grain bullets Full Metal Jacket the powder is Winchester 231 at 4.6 grains for the first 15 4.7 grains for the next 10. .
This should be a mid-range load but I'm not loading anymore until I test them at the range.
It will take a little getting used to seating primers on a press and developing the feel.
There were spent primers not going through the ram to the primer storage. They had built up under the shell plate. I cleared the obstruction cleaned everything very well and then reassembled the Press. Since I had everything apart I reinstalled the brass feeder and took out the plastic spring of the Lee safety Prime and as I've seen on YouTube placed a quarter inch Bolt spreading it apart and then dropped it in boiling water for 5 minutes.
Well I ran 25 rounds without a problem without dropping a single primer and with all cases feeding properly. The nightmare seems to be over. The loads are mixed brass Sierra 230 grain bullets Full Metal Jacket the powder is Winchester 231 at 4.6 grains for the first 15 4.7 grains for the next 10. .
This should be a mid-range load but I'm not loading anymore until I test them at the range.
It will take a little getting used to seating primers on a press and developing the feel.