Same problem I had. My solution is here: Changing Pocket Uniformers On Lyman Prep Center.Ohio3Wheels wrote: I'm not real crazy about the primer pocket cleaning bit. It doesn't seem to scrape all the crude off the bottom of the pocket and to save wear on the uniformer I like to get them clean before I do the uniforming. So I'm looking for a better solution.
Lyman brass station and a question?
- Ranch Dog
- Site Admin
- Posts: 6458
- Joined: 22 Jun 2013 17:16
- My Press Choice: Progressive
- Location: Inez, TX
- Has thanked: 1617 times
- Been thanked: 2851 times
Re: Lyman brass station and a question?
Michael
- Ranch Dog
- Site Admin
- Posts: 6458
- Joined: 22 Jun 2013 17:16
- My Press Choice: Progressive
- Location: Inez, TX
- Has thanked: 1617 times
- Been thanked: 2851 times
Re: Lyman brass station and a question?
I found a couple of more pictures of my Lyman Prep Center. These are the RCBS tools, I believe Redding look the exact same.
I do all my case trimming on the LPC as well, using the Lee Case Length Gauges (trimmers). Honestly just as quick to run all the cases through as it is to check them with calipers.
You might also find this helpful: Adjusting Case Length Gauges
I do all my case trimming on the LPC as well, using the Lee Case Length Gauges (trimmers). Honestly just as quick to run all the cases through as it is to check them with calipers.
You might also find this helpful: Adjusting Case Length Gauges
Michael
-
- Supporter
- Posts: 888
- Joined: 06 Mar 2016 16:09
- My Press Choice: Hand Press
- Location: SW Ohio
- Has thanked: 156 times
- Been thanked: 240 times
Re: Lyman brass station and a question?
I sent an order to Midway for a large pistol primer pocket uniformer and 2 stainless primer pocket cleaning brushes. I already have the Lee cutter set for the center.
Stay well, be safe, make smoke,
Stay well, be safe, make smoke,
Curt.......makin' smoke and raising my carbon foot print one cartridge at a time