Lee Loader

I need to remove the door that you open on the bottom of the Load Master ram to remove spent primers. I think I may have bent it by running the ram up with the door open so I need to replace it. Is it just a matter of removing the bolt on the bottom to remove the carrier and then take it all the way out? I'd like to know for sure before I start fiddling around with it.

cheech wrote:I need to remove the door that you open on the bottom of the Load Master ram to remove spent primers. I think I may have bent it by running the ram up with the door open so I need to replace it. Is it just a matter of removing the bolt on the bottom to remove the carrier and then take it all the way out? I'd like to know for sure before I start fiddling around with it.

From what I recall, yes, pull the draw bolt. Of course, that sets everything in motion to get it back together; indexing and tightening to the required torque.

It's been a looong time ago but I seem to remember there is a part you have to remove in the ram bottom to accomplish that. I could be wrong here but I also think I pulled the ram off (easy to do) to do that. Just be prepared for that possibility.

Thanks guys. I'm going in.