Hi Lee-Loaders.
Inspired of the Inline Factory Case-ejector, I´ve invented my own model, easy to make and very very cheap.
It consist of two cable-ties, one heavy acting as spring/ejector and one minor, securing the heavy one. Both tied around the farthest "leg" of my O-press. The end of the heavy just above and on the left side of the shellholder.
When placing the case in the shellholder, I push the end of the cable-tie to the right side of the ram. Holding the case against the cable-tie is easy, and when rising the ram, I can grab the next case. When the ram is lowered again, the cable-tie flips the case/cartridge into the bin placed on the edge of my bench right nex to the press.´I'm reloading 8x57 JS with 160 GR Barnes bullet in Hornady die.
See set-up and function here:
By the way, the pipe-bracket on the bottom of the press is for balancing the case-release-capsule of a RCBS-primer-pocket-swager:
Feel free to copy.
Niels.
DIY easy cheap case-ejector for press.
-
- Posts: 2
- Joined: 21 Jan 2021 06:19
- My Press Choice: Single Stage
- Location: Denmark
- Been thanked: 2 times
- sonic306090
- Posts: 64
- Joined: 11 Jan 2021 19:17
- My Press Choice: Turret
- Location: Channahon, IL
- Has thanked: 107 times
- Been thanked: 10 times
-
- Posts: 2
- Joined: 21 Jan 2021 06:19
- My Press Choice: Single Stage
- Location: Denmark
- Been thanked: 2 times
-
- Founding Member & Supporter
- Posts: 1123
- Joined: 20 Dec 2013 11:09
- My Press Choice: Single Stage
- Location: Arizona
- Location: Arizona
- Has thanked: 688 times
- Been thanked: 327 times
Re: DIY easy cheap case-ejector for press.
Cool. Good thinking..
A day late & A dollar short? Story of my life