Lee Loader

I found these two items on eBay, they are worth the money.

Roller Bearing Assist for Indexer


There is no installation. It slides right into place.

The roller assembly completely changes the press! Unbelievable!

KMS² UFO LM Reloading Press Light for Lee Loadmaster


I had bought one of the "center of the turret" lights, but I did not see it as the end of the visibility issue; plus, I'm too lazy to drill the center out on all my turrets. So when I saw the LED light ring, I was all in. It took about 5 minutes to install. The image is from my seated position operating the press. I don't need another die position for a powder cop type of die.

May just be the first time I have seen you tout an aftermarket part for a Lee press. Have I been asleep?

I just bought both of them. Thanks for the post. I have put my Load Master in the closet because of the indexer, Hopefully this will bring it back to life.

GasGuzzler wrote:May just be the first time I have seen you tout an aftermarket part for a Lee press. Have I been asleep?

Early on, I bought some mods but got to the point where I decided to start over and take it back to the way Lee made it and figure it out. That has been a while. I started on the Load-Master in '99.

I need to generate some cases for all my presses; that has become the tough part for me now.

Wow!!
I just received the Roller Bearing Assist mod and snapped it onto the Loadmaster.
It literally made the old workhorse into a new machine. The rotation advance is totally effortless and smooth now.

I just bought one of those lights for my Lee Turret press. Very nice, thanks!

Today the light was installed. Big improvement, now I can see the powder in each cartridge.