Here's a query that I asked Lee Customer Services and the answer wasn't clear.
The image shows the end of the Lee cartridge length gage, I have several of these, 308 win, 30/30, 223, 38 sp and 357 mag. On some of them the point B of the pin is proud of the face of the base of the cartridge and on others it isn't, this is when the gage is pushed fully home when the case is held in my hand.
Point A is the the end of the main section.
Is the length of the case dictated by point B or is it dependent on Point A?
I've run all my 308 cases through the trimmer with a drill and that point gets hot, as you can see it's blued from rubbing against the anvil in the case holder.
When trimmed back using point B, the cases measure 50.89mm, a midge's dick under 2.004".
On the tip or on the Butt?
- drone
- Posts: 34
- Joined: 11 Dec 2022 16:47
- My Press Choice: Hand Press
- Location: Dover, UK
- Has thanked: 4 times
- Been thanked: 8 times
On the tip or on the Butt?
You do not have the required permissions to view the files attached to this post.
Do you ever walk in a room and wonder why you're there?
Welcome to my world
Welcome to my world
- GasGuzzler
- Moderator & Supporter
- Posts: 2070
- Joined: 26 Jan 2016 22:39
- My Press Choice: Turret
- Location: Cooke County, TX
- Has thanked: 332 times
- Been thanked: 506 times
Re: On the tip or on the Butt?
A
B just centers on the flash hole.
I think.
I used Lee's system about 11 minutes before I went with a better design from a different company.
B just centers on the flash hole.
I think.
I used Lee's system about 11 minutes before I went with a better design from a different company.
__________________________________________________________________________________________
I've always been crazy but it's kept me from goin' insane.
I've always been crazy but it's kept me from goin' insane.
- RBHarter
- Founding Member
- Posts: 2065
- Joined: 13 Mar 2014 19:45
- My Press Choice: Single Stage
- Location: The green hell 90 miles north of Texarka
- Has thanked: 76 times
- Been thanked: 674 times
Re: On the tip or on the Butt?
Their system works by making a dead stop . The length from the outside of the case rim/head face to the cutter face is set by the insert rod through the case , flash hole , and stoping against holder set bolt .
In design it's absolute precision, absolutely 100% repeatable .
In practice it is close enough per cartridge, it doesn't allow for wear or long/short chambers without mods .
In design it's absolute precision, absolutely 100% repeatable .
In practice it is close enough per cartridge, it doesn't allow for wear or long/short chambers without mods .
Just a Red neck,White boy, Blue blood American.....