Home for the "Low Life Lee Lovers! The Forum for the Lee Precision Enthusiast! This site is not associated with Lee Precision nor is Lee Precision responsible for this site's content. https://lee-loader.com/
I have a channel too. I think it has one or two videos on it. I cannot remember how to log in. LOL
Re: Case holder ? 3D printed?
Posted: 03 Nov 2018 16:24
by GasGuzzler
Non-sequitor.....
Here is a video from my channel. I put the engine in this car. It's a stock 5.7L LS1 longblock WS6 Trans Am with a toot of juice and lots of suspension mods that allow it to reliably drive to the track and run QUICKLY.
[BBvideo 560,340][/BBvideo]
Turn up the volume before you watch this.
There's a terrible video of me whining about windmills and a sickening POV I took riding my 50-something year old brother in law's go cart I fixed for him at my parents' house. Also there's a hard to distinguish video showing a weird trigger reset on my old Blackhawk after I fitted a Bisely hammer. Lastly there's two videos showing the difference in 22 shorts and 22 Magnums out of an Old Model Single Six the weekend after my butt surgery.